Water Leveling

There are multiple ways to set the water level of the WAZER. It is important to do this before every cut, no matter which method you choose.

Tools Required

• none

Procedure

Classic method 

• If the water is low: use a hose or bucket to add water.
• if the water is high: lower by emptying out an abrasive bucket or use the Quick Drain method. 

Firmware Method

• Navigate through the controller menus  to Setup & Maintenance > Maintenance > Water Level Setup 

View fullsize

• It is important not to interrupt the machine during this process.  It may seem at times like nothing is happening but during that time the machine is slowly draining the water level to a desired level.

View fullsize