Additional Hardware for WAZER Maintenance/Workflow

Below is a list of additional hardware we use to keep the WAZER in it's ideal standards. We have also included some items you may want to pick up along the way, to make using and managing the WAZER smooth. Do not feel the need to immediately go out of your way to have these parts on hand at all times, but know that these items may come up during routine maintenance and workflows.

Included with WAZER

Pliers
Philips Screwdriver
6mm Hex
De-Burr tool
File Tool

Computer Hardware

Micro SD Card Reader/Adapter for updating Firmware on Control Board
SD Card Reader/Adapter for transferring cut profiles to and from the WAZER
Spare SD Card - We provide one with the WAZER, but a spare card on hand will increase convenience

Supplies

Batteries (9V) - For domestic shipments, we provide the water leak alarm with batteries pre-installed. Replace as necessary when batteries die.
Blue Goop is a thread lubricant used for screws under high hydraulic pressure
Teflon Tape is a thread sealant used to stop water leaking through screw threads
Canned Air/Air Compressor in order to get rid of clogs/moisture
Sandpaper/Grinder to help remove rough edges on materials. We do provide a simple file tool to help with this
Tank Cleaning Tools - Gloves, bucket, siphon hose, scoop. Tools to help perform full tank cleans
Blue Loctite 242/248 used only during maintenance/repair procedures regarding screw sealing
Red Loctite 5452/545 used only during maintenance/repair procedures regarding screw sealing

Safety Information

Do NOT forget to prime the water systems during set-up. Make sure air has left all the hose lines before attempting your first cut
Safety Eyewear can be used as user feels necessary while machine is under operation
Safety Ear Muffs should be used when staying close to the machine for extended periods of over 15 minutes
NO extension cords
Do NOT keep WAZER in freezing conditions for any amount of time